Setting Skybase Warps

So as you all might have noticed, setting warps on top of chests doesn't work. You can set the warp, but when you warp back to it you fall through the chest.

The way to set a warp in a skybase is as follows:

1) Build skybase.
2) Pick a location where you want your warp to be.
3) Remove the chest at that location, and replace with a solid full block (a normal cobble block will work).
4) Set a warp when standing on that block.
5) Replace block with chest.

What this will do is set a warp just above the chest (since the chest isn't a full block high). When you warp in, you will come in slightly above the chest, land on the chest, and not fall through.

The reason I have the helpful tip is because I just raided a base full of OP, iron, and other stuff, and found the base because there was a floating stone in the sky for the warp point. You never, ever want your skybase visible from ground....

 

Dem hackusations

Seriously though if you put solid blocks in a skybase you're asking to be raided

 

I
Do not
Use Minimaps.

(SerioulsyIDunnoHowToInstallOne)

The skybase was next to a village, I was raiding the village and saw the block. Also there was already a 10-block tall stack of cobble already there on the ground pointing at the base.